Have you added any hardware lately? Have you updated any driver just before these started? (Check
Control Panel - Windows Updates to see if any drivers were updated there about the time this started)
Main likely culprits are Video driver, other major drivers, memory, and antivirus/antispyware/security
products could be at fault as well as drive issues.
Use the troubleshooter below and refer to the next message for drivers and memory when you get to
those sections and then return back to the troubleshooter as needed.
BCCode: 50 0x00000050
Cause
The BCCode 50 usually occurs after the installation of faulty hardware or in the event of failure of installed
hardware (usually related to defective RAM, be it main memory, L2 RAM cache, or video RAM).
Another common cause is the installation of a faulty system service.
Antivirus software can also trigger this error, as can a corrupted NTFS volume.
Resolving the ProblemResolving a faulty hardware problem:
If hardware has been added to the system recently, remove it to see
if the error recurs. If existing hardware has failed, remove or replace the faulty component. You should run
hardware diagnostics supplied by the system manufacturer. For details on these procedures, see the owner's
manual for your computer. Resolving a faulty system service problem:
Disable the service and confirm that this resolves the error. If so,
contact the manufacturer of the system service about a possible update. If the error occurs during system
startup, restart your computer, and press F8 at the character-mode menu that displays the operating system
choices. At the resulting Windows Advanced Options
menu, choose theLast Known Good Configuration
option. This option is most effective when only one driver or service is added at a time. Resolving an antivirus software problem:
Disable the program and confirm that this resolves the error. If it
does, contact the manufacturer of the program about a possible update. Resolving a corrupted NTFS volume problem:
Run Chkdsk /f /r
to detect and repair disk errors. You must
restart the system before the disk scan begins on a system partition. If the hard disk is SCSI, check for
problems between the SCSI controller and the disk.
Finally, check the System Log in Event Viewer for additional error messages that might help pinpoint the
device or driver that is causing the error. Disabling memory caching of the BIOS might also resolve it. 作者: kenyik12 時間: 2014-1-23 06:21 PM
4#Cheval_Blanc佢又blue screen la ><
點算好幫幫我啊作者: kenyik12 時間: 2014-1-28 01:20 AM
4#Cheval_Blancthese is the picture i want to sed to you but i dont know how to use the inbox to upload the picture作者: Cheval_Blanc 時間: 2014-1-28 01:46 AM
maybe is windows system error.. format 机...作者: kns003 時間: 2014-3-21 12:39 AM
go download > Advance system care for clean up ,,try or download a MSE antivirus to scans virus. can try. MSE is ori from microsoft windows作者: ken_tsui_ck 時間: 2014-3-29 02:39 AM
try to boot up the windows in save mode first. Then try run IE on safe mode see it will reboot automatically or not.
if still reboot, there should be hardware error. change the RAM or display card to test.作者: feiyun002 時間: 2014-4-7 03:42 PM
Looks like virus..try install AVG2013 or other good anti-virus software scan it.
IE might got corrupted by virus